Brand new full tub capping kit 1994-2016 spec

This includes:

2x Main top cappings (AMN711210 & AMN711200)

2x Rear Light Cappings (these are the 94-2016 spec)

2x Small triangular cappings that sit on rear quarter panels

To fit Defender 90 models from 1994-2016 with the bulkhead behind the seats.

Will also fit models without the bulkhead, just cut the bit that protrudes out with an angle grinder or hack saw

These normally rust quite badly but luckily they are straightforward to replace as they are just held in place using 4.8mm rivets

This is pressed exactly as original and is pressed in one piece. So unlike others on the market which are made from 3 seperate pieces and then welded together which leaves 2 quite fat weld lines on each capping, these are completely smooth as per the Genuine Land Rover cappings.

Also, unlike other aftermarket cappings, each rivet hole where it should, has a pressed recess so the rivets sit flush with the capping once fitted. This is especially important along the top edge as otherwise the foam seal which sits on top rucks up over each one and will never seal as good as with these.

The attention to detail on these is fantastic

Comes in black e-coat which is better than powdercoat and is what most automotive body parts on modern vehicles come in prior to painting. The finish is perfectly smooth.